User guide

5-16
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 5 Wireless Menu Bar Selection
802.11 AP Interfaces > Performance Profile
802.11 AP Interfaces > Performance Profile
Use WIRELESS > Access Points > 802.11a Radios or WIRELESS > Access Points > 802.11b/g
Radios > Configure and then click Performance Profile to navigate to this page.
This page shows the details of the performance profile of the selected Cisco radio. The profile parameters
are detailed in the following table and should be enabled for global control.
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Table 5-16 802.11 General Parameters
Parameter Description
Interface Type Displays the Cisco radio type: 802.11a or 802.11b/g.
AP Name Displays the customer definable name of the access point.
AP ID Displays the access point identification number automatically assigned by
the controller.
Profile Parameters
Globally Controlled
Note You cannot change the following parameters if the Profile
Parameters Globally Controlled checkbox is selected.
Interference
(0 to 100%)
Foreign 802.11a or 802.11b/g interference threshold between 0 and
100 percent. Globally set on 802.11a Global Parameters > Auto RF and
802.11b/g Global Parameters > Auto RF pages.
Clients (1 to 75) Client threshold between 1 and 75 clients. Globally set on 802.11a Global
Parameters > Auto RF and 802.11b/g Global Parameters > Auto RF pages.
Noise (-127 to 0 dBm) Noise threshold between -127 and 0 dBm. Globally set on 802.11a Global
Parameters > Auto RF and 802.11b/g Global Parameters > Auto RF pages.
Coverage (3 to 50 dBm) 802.11a or 802.11b/g coverage threshold between 3 and 50 dBm. Globally
set on 802.11a Global Parameters > Auto RF and 802.11b/g Global
Parameters > Auto RF pages.
Utilization (0 to 100%) 802.11a or 802.11b/g RF utilization threshold between 0 and 100 percent.
Globally set on 802.11a Global Parameters > Auto RF and802.11b/g Global
Parameters > Auto RF pages.
Coverage Exception
Level (0 to 100%)
Coverage exception level between 0 and 100 percent. Globally set on
802.11a Global Parameters > Auto RF and 802.11b/g Global Parameters >
Auto RF pages.
Data Rate
(1 to 1000 Kbps)
802.11a or 802.11b/g throughput threshold between 1 Kbps and 1000 Kbps.
Globally set on 802.11a Global Parameters > Auto RF and802.11b/g Global
Parameters > Auto RF pages.
Client Min Exception
Level (1 to 75)
Client minimum exception level. Globally set on 802.11a Global Parameters
> Auto RF and 802.11b/g Global Parameters > Auto RF pages.