User guide

5-6
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 5 Wireless Menu Bar Selection
Cisco APs
Secondary
Controller Name
This is the access point’s secondary controller SNMP name. The access point
attempts to associate with this controller second for all network operations and
in the event of a hardware reset (See Note).
Tertiary Controller
Name
This is the access point’s tertiary controller SNMP name. The access point
attempts to associate with this controller third for all network operations and in
the event of a hardware reset (See Note).
Statistics Timer This counter sets the time in seconds that the access point sends its DOT11
statistics to the controller.
Note After the access point is reset, it attempts to connect with its primary, secondary, and tertiary
controller as configured on this page. If the access point’s primary, secondary, and tertiary
controller are not available, it searches for the master controller (Master Controller
Configuration) and finally the least loaded controller on the network.
Table 5-3 Radio Interface Details
Parameter Description
Number of interfaces One or Two 802.11a and/or 802.11b/g interfaces.
Interface Type Displays the Cisco radio type: either 802.11a or 802.11b/g.
Admin Status Displays the Cisco radio interface status: either enabled or disabled.
Oper Status Displays the Cisco radio operational status: either UP or DOWN.
Table 5-4 Versions
Parameter Description
Software Version Displays the Software version, for example, 3.0.80.0.
Boot Version Displays the Boot ROM versions for example, 11.20.0.
Table 5-5 Inventory Information
Parameter Description
AP Model Displays the model of the access point.
IOS Version Displays the IOS version of the access point.
AP Serial Number Displays the access point’s serial number, for example,
01012203-10057105-01182.
AP Certificate Type Displays the certificate type as either Self Signed or Manufacture
Installed.
Reap Mode Supported Not an editable field. Displays whether or not the access point can be
configured either as a access point, or Cisco Aironet 1030 IEEE
802.11a/b/g remote edge lightweight access point.
Table 5-2 General Details (continued)
Parameter Description