Installation Guide

10-3
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Chapter 10 Cisco S690 Web Security Appliance
Rear Panel Ports
Models with Fiber Optic Ports
The S690-1G and S690-10G models of the Cisco Web Security Appliance have Fiber Optic ports.
Figure 10-2 shows the rear panel ports of Cisco Security Appliances with Fiber Optic ports.
For information about rear panel LEDs, see Rear Panel LEDs and Buttons, page 10-6.
Figure 10-2 Rear Panel Ports of the S690-1G and S690-10G Web Security Appliances
Item Port Description
1 Management
interface 1
A fiber optic interface that is restricted to
management use only.
2 Management
interface 2
A fiber optic interface that is restricted to
management use only.
3 Traffic Monitor
port 1
The primary fiber optic port traffic monitor
port T1 for Duplex Ethernet tap: One cable for
all incoming and outgoing traffic.
4 Traffic Monitor
port 2
Traffic monitor port for Simplex Ethernet tap:
One cable for all packets destined for the
internet (T1), and one cable for all packets
coming from the Internet (T2).
5 Proxy port 1 The primary fiber optic port used to connect
proxy port P1 to the network for both incoming
and outgoing traffic.
6 Proxy port 2 When both proxy ports P1 and P2 are enabled,
you must connect P1 to the internal network
and P2 to the Internet. P1 and P2 can connect
to L4 switch, WCCP router, or network switch.
7 Remote Power
Cycle
The port that is used for Remote Power Cycle
(RPC).
8 Console The console port that directly connects a
computer to the appliance.