Installation Guide

10-2
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Chapter 10 Cisco S690 Web Security Appliance
Rear Panel Ports
Rear Panel Ports
The Cisco S690 Web Security Appliance is available with either Ethernet ports or Fiber Optic ports. The
description of these ports are described in separate sections below.
Models with Ethernet Ports
The S690 and S690X models of the Cisco Web Security Appliance have Ethernet ports.
Figure 10-1 shows the rear panel ports of the Cisco S690 Web Security Appliance with Ethernet ports.
For more information about rear panel LEDs, see Rear Panel LEDs and Buttons, page 10-6.
Figure 10-1 Rear Panel Ports of Cisco S690 Web Security Appliances
Item Port Description
1 Proxy port 1 Connect proxy port P1 to the network for both
incoming and outgoing traffic.
2 Proxy port 2 When both proxy ports P1 and P2 are enabled,
you must connect P1 to the internal network and
P2 to the Internet. P1 and P2 can connect to L4
switch, WCCP router, or network switch.
3 Traffic Monitor
port 1
Traffic monitor port T1 for Duplex Ethernet tap:
One cable for all incoming and outgoing traffic.
4 Traffic Monitor
port 2
Traffic monitor port for Simplex Ethernet tap:
One cable for all packets destined for the
internet (T1), and one cable for all packets
coming from the Internet (T2).
5 Remote Power
Cycle
Port that is used for Remote Power Cycle (RPC).
6 Console Console port that directly connects a computer
to the appliance.
7 Management
interface 1
The 1-Gigabit Ethernet interface that is
restricted to management use only.
8 Management
interface 2
The secondary Management Port. This
1-Gigabit Ethernet interface cannot be used.