Installation Guide

5-5
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Chapter 5 Cisco M190 Content Security Management Appliance
Summary of Features
Summary of Features
Table 5-3 lists the features of the M190 Content Security Management Appliance.
.
Data/Management port link status • Off—No link is present.
• Green—Link is active.
• Green, blinking—Traffic is present on the active link.
Rear unit identification
• Off—The unit identification LED is not in use.
• Blue—The unit identification LED is activated.
Table 5-2 Rear Panel LEDs, Definitions of States (continued)
LED Name State
Table 5-3 Cisco M190 Content Security Management Appliance Features
Feature Description
Chassis One rack-unit (1RU) chassis.
Processors One E5–2609 v3 processor.
Memory One 8GB DDR4-2133 DIMM
1
.
1. DIMM = dual inline memory module
Remote Power
Cycle
The Remote Power Cycle can be accessed through a
1-Gb dedicated port.
Data Ports Two 1-Gb BASE-T Ethernet LAN ports. Can also be used as Management ports.
Management I/O Supported connectors:
• One 1-Gb BASE-T Ethernet LAN ports
• One RS-232 serial port
Power One or two 770 W AC power supply.
Cooling Six fan modules for front-to-rear cooling.
Storage Two 600 GB hard disk drives (2.5” 10K SAS 4Kn) are installed into front-panel
drive bays that provide hot-swappable access for SAS drives.
Disk
Management
(RAID)
The appliance has a dedicated internal riser for a PCIe-style Cisco modular RAID
controller card.