Installation Guide

1-9

Cisco x90 Series Content Security Appliances Installation and Maintenance Guide

Chapter 1 Installing Cisco x90 Series Content Security Appliances

Installing Cisco x90 Series Content Security Appliances In a Rack

Figure 1-6 Attaching the Cable Management Arm to the Rear of the Slide Rails

Reversing the Cable Management Arm (Optional)

Step 1 Rotate the entire CMA assembly 180 degrees. The plastic cable guides must remain pointing upward.

Step 2 Flip the tabs at the end of each CMA arm so that they point toward the rear of the appliance.

Step 3 Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the

outside of the tab and pivot the tab 180 degrees so that it points toward the rear of the appliance.

1 CMA tab on arm farthest from the appliance

and end of stationary outer slide rail

3 CMA tab on width-adjustment slider and end

of stationary outer slide rail

2 CMA tab on arm closest to the appliance and

end of inner slide rail attached to the

appliance

4 Rear of the appliance

352584