User Guide

58
IRONPORT ASYNCOS 6.3 FOR WEB USER GUIDE
Figure 4-5 System Setup Wizard — Network Tab, Routes for Traffic Page
9. Configure the Routes for Management and Data Traffic options.
The number of sections on this page depend on how you configured the “Use M1 port for
management only” check box on the previous wizard page:
• Enabled. When you use the Management interface for management traffic only, then
this page includes two sections to enter gateway and static route table information,
one for management traffic and one for data traffic.
• Disabled. When you use the Management interface for both management and data
traffic only, then this page includes one section to enter gateway and static route table
information. AsyncOS uses the route information for both management and data
traffic.
Table 4-5 describes the Routes for Management and Data Traffic options.
Table 4-5 Routes for Management and Data Traffic Options in System Setup Wizard
Option Description
Default Gateway Enter the default gateway IP address to use for the traffic through the
Management and/or Data interface.