User Guide

CONFIGURING THE NETWORK INTERFACES FROM THE WEB INTERFACE
CHAPTER 21: CONFIGURING NETWORK SETTINGS 467
Figure 21-1 Editing Network Interfaces
2. Configure interface settings as necessary.
Table 21-2 describes the interface settings you can define for each interface.
3. Specify whether or not to have separate routing for the Management Services using the
“Restrict M1 port to appliance management services only” field.
If this checkbox is selected, the M1 port is used for appliance management services only
and is not used for the data (Web Proxy) traffic. You will need to configure another port for
data traffic as well as separate routes for management and data traffic. For more
information about configuring routes, see “Configuring TCP/IP Traffic Routes” on
page 469.
4. Configure Appliance Management Services.
Table 21-2 Interface Settings
Interface Setting Description
IP Address Enter the IP address to use to manage the Web Security appliance.
Enter an IP address that exists on your management network.
Netmask Enter the network mask to use when managing the Web Security
appliance on this network interface.
Hostname Enter the hostname to use when managing the Web Security
appliance on this network interface.