User Guide

352
IRONPORT ASYNCOS 6.3 FOR WEB USER GUIDE
Testing Authentication Settings in the CLI
You can use the testauthconfig CLI command to test authentication settings defined for a
given realm. The command syntax is:
testauthconfig [-d level] [realm name]
Running the command without any option causes the appliance to list the configured
authentication realms from which you can make a selection.
The debug flag (-d) controls the level of debug information. The levels can range between
0-10. If unspecified, the appliance uses a level of 0. With level 0, the command will return
success or failure. If the test settings fail, the command will list the cause of the failure.
Note — IronPort recommends you use level 0. Only use a different debug level when you
need more detailed information to troubleshoot.
For more information about the
testauthconfig command, see “Web Security Appliance
CLI Commands” on page 534.