Release Notes

23
Release Notes for Cisco CDA Visual Quality Experience Application Release 3.10
Installing VQE Release 3.10 Software
b. Saves the factory default configuration files under /etc to the directory /vqe-etc/etc-pristine.
6. Reboots the server.
Step 1 When the CDE111/ CDE250 2V0 completes the final reboot, you are required to log in as root and
change the password for root:
localhost.localdomain login: root
You are required to change your password immediately (root enforced)
You can now choose the new password or passphrase.
A valid password should be a mix of upper and lower case letters,
digits, and other characters. You can use an 8 character long
password with characters from at least 3 of these 4 classes, or
a 7 character long password containing characters from all the
classes. An upper case letter that begins the password and a
digit that ends it do not count towards the number of character
classes used.
A passphrase should be of at least 3 words, 12 to 40 characters
long and contain enough different characters.
Enter new password:
Re-type new password:
Step 2 Enter the new password for root.
When you change the root password, the VQE Startup Configuration Utility runs:
Welcome to the Cisco VQE startup configuration utility. This utility is
intended to facilitate the initial setup of the VQE system. This is not
intended as a complete configuration tool, but merely to assist in the most
common configuration needs, therefore you may still need to customize the VQE
configuration for your specific needs after this utility is complete.
The system is now ready to be configured.
Remotely Performing an ISO Full Upgrade Installation
(Continued from Step 5 in the “Remotely Performing an ISO Clean or ISO Full Upgrade Installation”
section on page 21)
The ISO full upgrade installation software checks that VQE software and configuration files exist. If
either of these checks fail, the installation is terminated.
If the VQE software and configuration files exist, the following message is displayed before the actual
upgrade process starts.
You are performing VQE upgrade on hostname. It currently has Cisco VQE Server_or_Tools
Release xxx installed. If this is incorrect, please power off the server within 60
seconds.
When you select an ISO full upgrade and the installation begins, no further user input is required or
possible.
An ISO full upgrade does the following:
• Checks whether the /etc configuration files have been changed manually (without the use of the
VCDB). If manual changes are detected, the ISO full upgrade installer does the following: