Release Notes

Release Notes for Cisco CDA Visual Quality Experience Application Release 3.10

Installing VQE Release 3.10 Software

The following example shows output from the script when an upgrade installation is selected.

This script will perform the remote iso installation on this server.

Please Enter Full Path of the ISO Image : /tmp/vqes-3.x.x-xx.xxx_xx.iso

Please enter the installation type : clean/[upgrade] : Enter

Setting up Second Disk for Remote ISO Installation... | Done

Please validate the installation options and enter "y" at prompt to proceed

NOTE: Server will be REBOOTED if you choose to proceed with the installation

Install Type : upgrade

Current Version : Cisco VQE Server Release 3.3.X (Build XX)

Post-Install Version : Cisco VQE Server Release 3.3.X (Build XX)

Install Setup Log : /var/log/vqe/remote_iso_install.log

Do you want to proceed with the installation? y/[n]: y

Proceeding with upgrade install...

Logfile for Remote Installation Setup will be available after installation

at : /var/log/vqe/remote_iso_install.log

Setting up filesystems for remote iso install... \ Done

Rebooting Server in 5 seconds to start Remote ISO Installation...

Press CTRL-C if you want to abort now.

Broadcast message from root (pts/0) (Sun Mar 29 22:05:38 2009):

The system is going down for reboot NOW!

Step 5 When the CDE111/ CDE250 2V0 reboots, the ISO clean installation or ISO full upgrade installation

begins. Depending on the type of installation you are performing, go to one of the following sections:

• For an ISO clean installation, go to the procedure in the next section, “Remotely Performing an ISO

Clean Installation” section on page 22.

• For an ISO full upgrade installation, go to the procedure in the “Remotely Performing an ISO Full

Upgrade Installation” section on page 23.

Remotely Performing an ISO Clean Installation

(Continued from Step 5 in the preceding section.)

When the ISO clean installation begins, no further user input is required or allowed until the initial

configuration of the CDE111/ CDE250 2V0 server.

An ISO clean installation does the following:

1. Formats the hard disk.

2. Installs the Linux operating system and all packages.

3. Reboots.

4. Installs the add-on RPM of VQE packages and configuration files.

5. Performs installation post processing.

a. Installs a new vcdb.conf.sample file in the /etc/opt/vqes/ directory.