Release Notes

19
Release Notes for Cisco CDA Visual Quality Experience Application Release 3.10
Installing VQE Release 3.10 Software
3. Reboots.
4. Installs the add-on RPM of VQE packages and configuration files.
5. Performs installation post processing.
a. Installs a new vcdb.conf.sample file in the /etc/opt/vqes/ directory.
b. Saves the factory default configuration files under /etc to the directory /vqe-etc/etc-pristine.
6. Reboots the server.
Step 4 Remove the ISO CD from the CDE111/ CDE250 2V0 CD/DVD Combo drive and close the drive tray.
Step 5 When the CDE111/ CDE250 2V0 completes the final reboot, you are required to log in as root and
change the password for root:
localhost.localdomain login: root
You are required to change your password immediately (root enforced)
You can now choose the new password or passphrase.
A valid password should be a mix of upper and lower case letters,
digits, and other characters. You can use an 8 character long
password with characters from at least 3 of these 4 classes, or
a 7 character long password containing characters from all the
classes. An upper case letter that begins the password and a
digit that ends it do not count towards the number of character
classes used.
A passphrase should be of at least 3 words, 12 to 40 characters
long and contain enough different characters.
Enter new password:
Re-type new password:
Step 6 Enter the new password for root.
When you change the root password, the VQE Startup Configuration Utility runs:
Welcome to the Cisco VQE startup configuration utility. This utility is
intended to facilitate the initial setup of the VQE system. This is not
intended as a complete configuration tool, but merely to assist in the most
common configuration needs, therefore you may still need to customize the VQE
configuration for your specific needs after this utility is complete.
The system is now ready to be configured.
Performing an ISO Clean or ISO Full Upgrade Installation from a Remote
Location
Because of the cost and time delay, it is sometimes not desirable for the service-provider technician to
be physically present at the CDE111/ CDE250 2V0 server when an ISO clean or ISO full upgrade
installation is performed.
Starting with VQE Release 3.3.1, an ISO clean or ISO full upgrade installation can be performed from
a remote location without inserting an ISO software installation CD into the CDE111/ CDE250 2V0
server. The remote ISO installation is available for both VQE Server and VQE Tools software.
The following sections explain how to perform a remote ISO software installation: