Maintenance Manual

Site Configuration
Monitoring and Notification
54
2. Do one of the following:
– Click Add to add a new trap destination.
– Select a listed trap destination and then click Edit to change the IP
address.
– Select a listed trap destination and then click Remove to delete IP address.
3. When you finish, click OK to save your changes.
AFTER COMPLETING THIS TASK:
Restart the Windows SNMP service to enable your changes.
NOTE: You must restart the SNMP service any time you make a
change in trap destinations.
Using Email Addresses for Notification
Notifications can be sent to either the Event Viewer or in emails to specified recipients.
To use email notification, enable the Use Email Notification check box and then
configure up to 5 email addresses.
Notification emails will be sent from the sender email address configured in the SMTP
Configuration dialog box. If you are using email notification, you must configure SMTP.
This can be done only from the Quality Management server.
Figure 15. SMTP Configuration dialog box