Maintenance Manual
Site Configuration
Monitoring and Notification
53
Configuration Settings Used By Services
If you change the settings on the Monitoring and Notification window, Table 19 shows
when your changes take effect.
Table 19. When services start using the changed configuration settings
Configuring the SNMP Settings
Use this task to configure SNMP settings for notification.
TASK
1. Select the Use SNMP Notification check box, and then click SNMP Configuration.
S
TEP RESULT: The SNMP Configuration dialog box appears.
Every N Polling
Periods
Choose this option and enter how frequently you want renotification to
occur after the initial notification. For example, if you choose to be notified
every 3 polling periods, you receive the initial notification on the first
polling period the problem is detected, no notification the next two polling
periods, and then another notification on the next polling period. This
pattern will continue as long as the problem is detected.
Every Polling
Period
Choose this option if you want renotification to occur every polling period
after the initial notification.
Available
Problems
The list of problems that can trigger notification if enabled by using the
arrow keys to move them to the Enabled Problems section. By default only
one problem, QM3002, is not enabled and in this list.
Enabled
Problems
The list of enabled problems. By default, all problems except for QM3002
are enabled. If QM3002 is enabled, a Setup button appears in the Setup
column. Click the Setup button to configure the Call Detail Record (CDR)
task.
NOTE: QM3002 is not supported with MediaSense
See “Configuring the QM3002 Notification Trigger” on page 60 for more
information.
Field Description
Service Configuration Settings Applied
MANA service The next polling period applies the configuration settings.