Maintenance Manual

Site Configuration
Upload Settings
48
Configuration Settings Used By Services
If you change the settings on the Upload Settings window, Table 15 shows when your
changes take effect.
Table 15. When services start using the changed configuration settings
Max Peak
Uploads
The maximum number of recordings that can upload simultaneously
during peak hours. Must be a value from 1 to 100. This limit is set to
conserve bandwidth on the network. When one upload completes,
another takes its place, but there can be no more than the configured
number uploading at any one time. Default = 5.
Max Off Hour
Uploads
The maximum number of recordings that can upload simultaneously
during off hours (the hours not specified as peak hours as defined by the
Peak Hours Begin and Peak Hours End fields). Must be a value from 1 to
200. This limit is set to conserve bandwidth on the network. When one
upload completes, another takes its place, but there can be no more than
the configured number uploading at any one time. Default = 100.
Database
Cleanup Time
The time when the DB Cleaner utility runs. This utility deletes expired
recordings from the database. Must be between 00:00 and 23:59 in
1-minute increments. Choose a time when no uploads are occurring to
reduce the load on the system. Default = 00:05.
Screen Server (Read-only) Provides the IP address for the Screen server and the path to
the screen recordings. If the AQM license is not installed, this does not
appear.
This section only appears after Voice and Screen services are installed on
the Screen server.
Voice Server (Read-only) Provides the IP address for the Voice server and the path to
the audio recordings.
This section only appears after Voice and Screen services are installed on
the Voice server.
Field Description
Service Configuration Settings Applied
Upload Controller
service
The next End of Day applies the configuration settings.
DB Cleaner service The next cleanup time applies the configuration settings.
FTS webapp (Jetty
service)
Start the Jetty service.