Installation Guide
Table Of Contents
- Overview
- Installing QM
- Introduction
- Prerequisites
- Installing QM Services
- QM Configuration Setup
- Setting Up NT Authentication for the Cisco Unified CC Database
- Setting Up Named Pipes for the Cisco Unified CC Database
- Installing QM Desktop Applications
- Using Automated Package Distribution Tools
- Removing QM
- Index
QM Configuration Setup
June 2007 27
QM Configuration Setup
The QM Configuration Setup tool is used to enter the system configuration information
needed for a successful QM installation.
QM Configuration Setup is launched automatically in Initial Mode after you install a
QM service. Any time you launch QM Configuration Setup thereafter, it is launched in
Update Mode.
Entering Configuration Data in Initial Mode
After a QM service is installed, QM Configuration Setup starts automatically. It does
not display the same windows for each service installation, but only those relevant to
that service.
To enter configuration data in Initial Mode:
1. Configuration Setup starts automatically and displays the Quality
Management Directory Services dialog box (see
Figure 6).
Figure 6. QM Directory Services dialog box.
2. Enter the IP address of the computer where the QM Directory Services is
located and the IP address of the computer where the QM service you just
installed is located, and then click OK.
The Change QM Administrator Password dialog box appears (see Figure 7).