Installation Guide

Configuring the Member

Begin the Installation and Configuration for the Member Node

Note: All conﬁgured nodes in a cluster must be up and running before you install a new Member

node.

Completing the Configuration for the Member Node

Step 1

To install the member node over MCS Server, insert the DVD into the tray and perform all steps

in Chapter 2 (page 11), starting with the Media and Hardware Check (page 15) and proceeding

through to the First Node Conﬁguration screen (page 18)

To install the member node over UCS Server, perform the steps in Chapter 2 (page 11), under

the following sections:

•

Deploy the Uniﬁed IC Open Virtualization Format/Open Virtual Appliance (OVF/OVA)

Template on the Virtual Machine (page 12)

•

Specify the Location of the Uniﬁed IC Installable (page 13)

•

Install Uniﬁed IC on the Virtual Machine (page 14)

Step 2

At the First Node Conﬁguration Screen, select No.

The First Node Conﬁguration Warning screen opens.

This screen advises you that you must conﬁgure the server on the ﬁrst node before you can

proceed. You did this in Chapter 4 (page 30).

Step 3

Select OK at the screen.

Installation and Upgrade Guide for Cisco Unified Intelligence Center Release 8.5(2)

Chapter 7