Installation Guide

Sign in to the Administration Console
After you install the Controller, you must sign in to the Administration Console to perform tasks
as explained in this chapter.
To sign in, open a browser and enter the URL for your Controller (http://<HostAddress>/oamp),
where HostAddress is the host name or IP Address of the Controller. This opens the
Administration Console.
Sign in using the System Application (page 54) credentials.
This chapter contains the following topics:
•
Upload the License, page 29
•
Define the Member Node in the Administration Console, page 30
•
Verify the Controller is Synchronized with the NTP Server, page 30
Upload the License
You have limited functionality on the Administration Console and no access to the Unified IC
Reporting interface until you upload the license file.
To upload the license:
1. Sign in to the Administration Console and select Cluster Configuration > License
Management.
2. Select Upload license file (Browse) and navigate to the local directory where your license
is stored.
Then click Apply License to load the license.
See also Licenses (page 50).
Installation and Upgrade Guide for Cisco Unified Intelligence Center Release 8.5(2)
29
Chapter 6