Installation Guide

Figure 3: Cryptographic Screen
•
Application Post-Install Progress Bars
The installation ends at a login prompt, at which you can enter CLI commands.
To access the web interface, you need to open a browser and enter the URL http://Controller
hostname or IP/oamp and User ID/Password of the System Application (page 54) user.
Installation Failure
Insert the DVD into the tray and perform all steps in Chapter 2 (page 11), starting with the
Media and Hardware Check (page 15) and proceeding through to the First Node Configuration
screen (page 18).
If a critical error occurs during installation, you are prompted to collect log files. To do this,
insert a USB memory key in any available USB port and follow the instructions on the screen.
See What Do I Do if the Installation Fails? (page 55).
If the installation fails over a Virtual Machine, see What Do I Do if the Installation Fails? (page
55).
After the Installation
The action to take when the installation completes depends on the type of node you installed.
ThenIf
The installation is complete.If you have installed a Controller, and your
cluster consists of a Controller node only
1. Open a browser and enter the URL for
your Controller ( http://Controller
Installation and Upgrade Guide for Cisco Unified Intelligence Center Release 8.5(2)
27
Chapter 5: Installation
Installation Failure