Manualshelf

Installation Guide

ManualsBrandsCisco ManualsCollaboration EndpointsCisco Unified Intelligence Center 9.0(2)
21222324252627282930
Basic Install Configuration Information
The Basic Install launches a series of screens that present questions and options pertinent to the
platform and the setup configuration. There is online help for each wizard screen.
Note: You can change many of the basic installation configuration settings after the installation
using the Set commands in the Command Line Interface (CLI). The CLI is documented in the
Administration Console User Guide for Cisco Unified Intelligence Center.
The first Basic Install wizard screen is Timezone Configuration.
Step 1
In the Timezone Configuration screen:
a.
Use the down arrow to select the local timezone that most closely matches where your
server is located. You can also type the initial character of the timezone to move to that
item in the list. The timezone field is based on country/city and is mandatory. Setting it
incorrectly can affect system operation.
Note: Use the same timezone for all nodes.
b.
Select OK to open the Auto Negotiation Configuration screen.
Step 2
In the Auto Negotiation Configuration screen, select whether or not you want to use automatic
negotiation for the settings of the Ethernet network interface card (NIC).
ThenIf
Select No to open the NIC Speed and
Duplex Configuration screen, where you
can manually configure the settings.
You want to disable auto-negotiation and specify
NIC speed and duplex settings.
Proceed to Step 3.
Select Yes to open the MTU Configuration
screen.
The ethernet network interface card (NIC) attached
to your hub or Ethernet switch supports automatic
negotiation.
Proceed to Step 4.
Step 3
In the NIC Speed and Duplex Configuration screen, configure settings as follows:
a.
Specify the speed of the Network Interface (NIC) card in megabits per second. Speed
options are 10 or 100.
b.
Specify the duplex setting of the server NIC. Options are Full or Half.
c.
Select OK to open the MTU Configuration screen.
Step 4
In the MTU Configuration screen, select No to keep the default setting for Maximum
Transmission Units (1500). If you do not accept the default and configure the MTU size
incorrectly, your network performance can be affected.
Installation and Upgrade Guide for Cisco Unified Intelligence Center Release 8.5(2)
17
Chapter 3: Beginning the Installation - All Nodes