Installation Guide

–
You must enter the same security password on all nodes in the cluster. Keep a record of
this password; you will need to use it if you replace or add a server in the future or if you
want to replace the old secutiry password with a new one.
–
Use the default Maximum Transmission Unit (MTU) setting, which is 1500, for all nodes
in the cluster.
Completing the Configuration Worksheet
Use this worksheet to record network and password information that the basic installation
configuration wizard prompts you to enter. Store this worksheet information for future reference.
Table 1: Configuration Worksheet
Your EntryConfiguration Data
Controller __________________________Host Name
Member 1 _________________________
Member 2 _________________________
Controller __________________________IP Address
Member _________________________
__________________________
Gateway (GW) Address
Controller __________________________Primary DNS IP Address
Member _________________________
Controller __________________________Secondary DNS IP Address
Member _________________________
_________________________Domain
__________________________
System Administrator (page 53)
Username
Note: As a best practice, use the same
System Administrator credentials for all
nodes.
__________________________System Administrator Password
__________________________
Timezone
Use the same Timezone for all nodes.
Organization:__________________________Certificate Information
Unit:__________________________
Installation and Upgrade Guide for Cisco Unified Intelligence Center Release 8.5(2)
7
Chapter 1: Before You Install
Completing the Configuration Worksheet