Maintenance Manual

•
Save saves the configuration information you entered above for active directory. Note that
clicking Save does not validate the configuration. Use the Test Connection button to test
the connection.
•
Refresh undoes all changes since the last save and reloads the values set at the last save.
Report Scheduler Email Settings Tab
Use the Report Scheduler Email Settings tab to configure the email server used to email scheduled
reports.
The actual schedules for reports (for example, schedule daily at 10AM) are defined and
maintained from the Unified IC web application. The report scheduler emails scheduled reports
at the exact time they are scheduled.
To navigate to this page, click Cluster Configuration > Reporting Configuration and select
the Report Scheduler Email Settings tab.
Table 14: Fields on this tab
DescriptionField
Enter the Hostname or IP address of the SMTP Server. Leave
this field blank if you do not have an SMTP server.
SMTP hostname/IP address
Enter the email address that is to appear in the From field of
emails sent by the Scheduler.
From email address
Check this if you use a proxy server to reach your SMTP server.Use email proxy
The only supported proxy type is http.
Enter the Hostname or IP address of the proxy server used to
reach the SMTP server.
Email proxy hostname
Enter the port the Unified IC will use to connect to the SMTP
proxy server. This defaults to 80.
Email proxy port
Check this if your SMTP server expects to receive
username/password credentials.
Use SMTP authentication
If you check the Authenticate checkbox, enter the username
that is to be authenticated.
SMTP Username
If you check the Authenticate checkbox, enter the password
that is to be authenticated.
SMTP Password
Click to test the connection. Unified IC attempts to send an
email to check for open connections. The connection status
displays next to the button.
Test Connection button
Actions on this tab:
•
Save saves the configuration information you entered above for active directory. Note that
clicking Save does not validate the configuration. Use the Test Configured Connection
button to test the connection.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
31
Chapter 5: Cluster Configuration Drawer
Reporting Configuration