Maintenance Manual

When the log level is basic, the trace definitions are not editable.
Detailed
If you check the detailed log level, the trace check boxes for Subsystem Specific Trace Definitions
and Infrastructure Trace Definitions become editable. You can check the boxes to turn on specific
trace code paths to output to the log file.
Figure 7: Select Detailed to edit Trace Definitions
Trace Definitions are documented in the Administration Console User Guide for Cisco Unified
Intelligence Center. They are not documented in the Online help.
There are two ways to review log and trace information:
•
The Command Line Interface (show trace).
•
RTMT (page 47)
Infrastructure Trace Definitions
Infrastructure Trace Definitions are the same for CUIC and for Operation Administration
Maintenance and Provisioning (OAMP) Infrastructure and OAMP-BO. There are no Infrastructure
Trace Definitions for OAMP WSM_BO.
DescriptionTrace
Description of the exception and how it was
handled
TRACE_HANDLED_EXCEPTION
JMX and management interface related traces.TRACE_JMX
JMS and message bus related traces.TRACE_JMS
Related to heartbeats, heartbeat thread, or
heartbeat send/received
TRACE_HEARTBEAT
For any parameters (not just method arguments)TRACE_PARAM
For traces related to a call / call processingTRACE_CALL
For general debug details of incoming/outgoing
messages
TRACE_MESSAGE
Trace for notification APITRACE_NOTIFICATION
General traces for config APITRACE_GENERAL_CFG
Set this bit to enable OoOQueue tracingTRACE_OOOQUEUE
When entering/exiting a methodTRACE_METHOD
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
22
Chapter 3: Device Management Drawer
Log and Trace Settings