Maintenance Manual

When a log size exceeds 50, a new log file is created.
Syslog Settings
Use these fields to identify the server where the log files are stored.
Table 11: Log file storage rows
DescriptionField
The host address of the primary syslog server that stores the
log files.
Primary Host
Note: The port is fixed at 514.
The host address of the backup syslog server that stores the
log files.
Backup Host
Note: The port is fixed at 514.
Subsystem Settings
Navigate in this expandable list of subsystems to set the log levels and trace definitions (page
21) for each subsystem.
Figure 6: SubSystem Settings
Actions on this page
•
Save - Saves the changes you have made.
•
Cancel - Undoes all changes you have made since the last save.
•
Refresh - Undoes all changes and revert fields back to the default values.
•
Reset - restores the original settings and does not keep your changes.
See also: Log Levels and Trace Level Definitions: Basic and Detailed (page 21)
Log Levels and Trace Level Definitions: Basic and Detailed
There are two log levels for all subsystems:
Basic
This is the default log level. With this setting, messages and warnings are displayed (INFO,
ERROR, and WARN).
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
21
Chapter 3: Device Management Drawer
Log and Trace Settings