Maintenance Manual

Figure 3: Member Configured

Now that the Member is deﬁned in Device Conﬁguration, you can begin to conﬁgure and install

as documented in the Installation Guide for Cisco Uniﬁed Intelligence Center.

Device Configuration Detail

Use the device conﬁguration detail page to deﬁne information about a new device or to edit

information about an existing device.

To navigate to this page, click Device Management > Device Conﬁguration. Then click Add

Controller or Add Member to add and conﬁgure a new device or click an existing device name

to edit the detail conﬁguration for that device

Text at the top of the page shows the type of server you are adding or editing.

Table 9: Rows on this page

DescriptionField

The name of the device. (Required)Name

The IP address or hostname of the device. (Required)Host Address

You cannot edit the IP address of the Controller on this page.

Note: There is a CLI command to change the IP address of the Controller,

but that command is unsupported for Uniﬁed IC.

You can edit the IP address of a Member on this page, but changing it here

does not effect a change in the cluster. The cluster continues to recognize

the original IP address for replication, and the replication will fail.

Note: There is a CLI command to change the IP address of the Member, but

that command is unsupported for Uniﬁed IC. The only way to change the

IP address of a member node is to reinstall the member node.

Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)

Chapter 3: Device Management Drawer

Device Configuration