Maintenance Manual

Defining the Member Node in the Administration Console
If you intend to add a Member node, you must define the Member in the Administration console
before you run the installation for the member.
Step 1
To access the Administration console, direct a browser to the URL http://<HOST ADDRESS>/
oamp where HOST ADDRESS is the IP Address or Hostname of your server.
Step 2
Sign in using the system application user ID and password that you defined during installation.
Step 3
From the panel in the left, select the Device Management drawer. Then select Device
Configuration.
Figure 2: Device Configuration
The Device Configuration page shows the Controller that you have installed. Note that the
hostname defaults to the alias CUIC1. (You can change it.)
Step 4
On the Device Configuration page, click Add Member.
Step 5
On the Device Configuration fields for the new member, enter a name by which you can identify
the member, the hostname or IP address, and a description for the device.
Step 6
Click Save.
The Member appears on the Device Configuration list.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
17
Chapter 3: Device Management Drawer
Device Configuration