Maintenance Manual

This list always contains at least one row for the Controller, which is added by the installation.
You cannot delete the Controller from this page. To delete the Controller, you must uninstall
it.
Note: Before you can install a new Member node, you must define the Member in this interface.
The rows on the Device Summary page contain four columns. There is a checkbox to the left
of each row for selecting that device for deletion. Click the checkbox in the heading row to
select all devices.
Table 7: Rows on this page
DescriptionField
The name of the device is a link. Click a name to edit the configuration for
that device.
Name
The software assigns default alias names - for the Controller, CUIC1; for the
members, Member1, Member2, and so forth.
You can edit the default aliases to names that are more meaningful for you.
The IP address for the device.Host Address
A description of the device.Description
The type of device: Controller or Member.Type
•
There is one Controller. It runs both the Administration console and Unified
IC Reporting.
•
There can be a maximum of seven Members. Members run the Unified IC
Reporting.
Table 8: Actions from this page
Do ThisTo
Click Add Member to open a blank Device Configuration Detail
(page 18) page for a new member. This button is disabled if you have
Add Member
not applied a license or when you have the maximum number of
members allowed by your license.
Check the box at the left of the device row and click Delete.Delete a device
You cannot delete the Controller.
The interface allows you to delete Members, but you must reinstall a
Member device to add it back to the cluster.
Each device name is a link. Click the name link to open its Device
Configuration Detail (page 18) page.
Edit an existing device
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
16
Chapter 3: Device Management Drawer
Device Configuration