Maintenance Manual

Figure 20: Using ACE
From the ACE console, enter the command do show serverfarm CUIC_FARM_SRV to
monitor the loading.
Step 1
Create the Ethernet interface:
•
interface gigabitEthernet 1/1 (using your port)
•
description Ethernet port (port 1 is configured for speeds of 100 Mbps and full-duplex
operation)
•
switchport access vlan 300 (using your vlan number) no shutdown
Step 2
Create the resource server RC_Web
resource-class RC_Web
limit-resource all minimum 0.00 maximum unlimited
limit-resource sticky minimum 10.00 maximum unlimited
Step 3
Associate the resource with Admin context: context
context Admin member RC_Web
Step 4
Define the server nodes:
rserver host CUIC-SRV-1
Ip address 10.86.228.30
inservice
rserver host CUIC-SRV-2
Ip address 10.86.228.31
inservice
rserver host CUIC-SRV-3
Ip address 10.86.228.32
inservice
rserver host CUIC-SRV-4
Ip address 10.86.228.33
no inservice
rserver host CUIC-SRV-5
Ip address 10.86.228.34
no inservice
rserver host CUIC-SRV-6
Ip address 10.86.228.35
no inservice
rserver host CUIC-SRV-7
Ip address 10.86.228.36
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
154
Load Balancing