Maintenance Manual

utils csa enable
utils csa disable
utils csa status
utils dbreplication
utils dbreplication clusterreset HARI
This command is used to reset replication on an entire cluster.
Caution:
Before executing this command, run the command utils dbreplication stop on all Member
nodes and then on the publisher (the Controller node).
COMMAND: utils dbreplication clusterreset
utils dbreplication dropadmindb
This command is used to drop the Informix syscdr database on any server in the cluster.
Caution: Run this command only if the command utils dbreplication reset or utils
dbreplication clusterreset fails and replication cannot be restarted.
COMMAND: utils dbreplication dropadmindb
utils dbreplication repair
This command repairs mismatched data on a named node or between nodes. It does not repair
replication setup.
COMMANDS:
utils dbreplication repair nodename
utils dbreplication repair all
utils dbreplication reset
This command is used to reset replication.
Caution: Run this command only when replication setup has failed after an install or
upgrade.
Before running this command, you must execute utils dbreplication stop. If resetting all, stop
replication on all nodes first. If resetting <nodename>, stop replication on that node first.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
138
Command Line Interface
Utils Commands