Maintenance Manual

• This CLI command can only be run on the Controller node. To set traces on the Member
nodes you must use the Operations Console command Device Management > Log And
Trace Settings
COMMANDS:
show trace <cuicserver> <oampserver>
PARAMETER: CUIC
PARAMETER: INFRASTRUCTURE
Options: Subsystems: OAMP| OAMP_BO | Infrastructure | WSM_BO
show ups status
This command communicates with an attached Uninterruptible Power Supply and displays
status.
COMMAND: show ups status
show version
This command displays the software version on the active or inactive side.
COMMAND: show version [active | inactive]
The indicator to the active or inactive partition is required.
show web-security
This command displays web security information.
COMMAND: show web-security
show workingdir
COMMAND: show workingdir
This command displays the current working directories for the activelog and inactivelog.
Unset Command
•
unset cuic-properties (page 135)
•
unset ipsec (page 135)
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
134
Command Line Interface
Unset Command