Maintenance Manual

Use this commands to enable or disable password complexity rules.
set password expiry maximum-age minimum-age
set password history number
set password inactivity enable | disable |period (days)
Use these commands to enable the operating system password inactivity to the default value of
10 days, to disable password inactivity, or set the number of days.
set password user admin security
These commands allow you to change the system administrator and security passwords.
The system prompts you for the old and new passwords and checks the password for strength.
PARAMETERS:
character takes {enable | disable}
When enabled, passwords need to meet these guidelines:
•
have at least one lower-case character
•
have at least one uppercase, one digit and one special character.
•
contain no characters that are adjacent on the keyboard
•
have not been used as any of the previous ten passwords. 5. The admin user password can
only be changed only once in 24 hours.
•
cannot have been changed in the past 24 hours.
minimum-length
When enabled, modify the value of minimum password length for CUCM OS accounts.
Acceptable values should be equal to or greater than 6. Use this command only after enabling
the character complexity of passwords.
maximum days Use this command to set the value of the maximum age for the admin accounts
in days. Acceptable values should be equal to or greater than 10 days but less than 3650 days
(10 years).
minimum days Use this command to set the minimum password age for the admin accounts in
days.
maximum-age takes {enable | disable)
Enabling the maximum age sets the value of maximum password age to 3650 days (10 yrs) for
CUCM OS admin accounts.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
111
Command Line Interface
Set Commands