Maintenance Manual

set network restore

This command restarts the networking on this host. If conﬁrmed, this command causes a

temporary loss of network connectivity.

Caution: Only use this command when all other CLI 'set network ...' commands have

failed to restore network connectivity to an Ethernet port. This command removes all

previous Ethernet and Network Fault Tolerance settings. The speciﬁed Ethernet port is

conﬁgured with a minimal static IP address conﬁguration. It is imperative that the original

Ethernet port settings be reconﬁgured AFTER this command using other CLI 'set network

...' commands.

COMMAND: set network restore <ethernet port> <ip-address> <network-mask> <gateway>

PARAMETERS:

ethernet-port is the Ethernet port (for example, eth0).

ip-address is the IP address of the host.

network-mask is the network mask.

gateway is the Gateway IP address.

set network status eth0

This command sets the state of the ethernet interface eth0 to up or down.

Caution: Only use this command when all other CLI 'set network ...' commands have

failed to restore network connectivity to an Ethernet port. This command erases all previous

Ethernet and Network Fault Tolerance settings. The speciﬁed Ethernet port is conﬁgured

with a minimal static IP address conﬁguration. It's imperative that the original Ethernet

port settings be reconﬁgured AFTER this command using other CLI 'set network ...'

commands.

COMMAND: set network status eth0 state {up | down}

PARAMETER state {up | down} to set the status up or down is required.

set password

Use these commands to conﬁgure password rules.

COMMANDS:

set password age maximum | days minimum | days

set password complexity character minimum-length

Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)

110

Command Line Interface

Set Commands