Maintenance Manual

addr is the IP address.
mask is the mask.
set network max_ip_conntrack
This command sets the maximum value for ip_conntract_max.
COMMAND: set network max_ip_conntrack ip_conntrack_max
PARAMETER ip_conntrack_max indicates the maximum value
set network mtu
This command sets the maximum MTU value. The valid range is 500-1500.
COMMAND: set network mtu size
PARAMETER size must be 1500 for all servers in the cluster.
set network nic eth0
This command sets the properties of the Ethernet Interface 0. It asks if you want to continue. If
you continue, this command causes a temporary loss of network connections while the NIC is
reset.
COMMAND: set network nic etho0 auto [en | dis] speed [10 | 100] duplex [half | full]
PARAMETERS: At least one is mandatory. Each parameter takes options indicated.
auto specifies whether auto negotiation gets enabled or disabled.
speed specifies the speed of the Ethernet connection: 10 or 100 Mbps.
duplex specifies half-duplex or full-duplex.
set network pmtud
This command enables or disables Path MTU Discovery.
The system asks whether you want to continue to execute this command. If you continue, the
system temporarily loses network connectivity.
COMMAND: set network pmtud state {enable | disable}
PARAMETER state {enable | disable}
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
109
Command Line Interface
Set Commands