Maintenance Manual

set network hostname
This command sets the netwrok hostname and then causes a restart of the system The hostname
must follow the rules for ARPANET host names. The hostname must start with an alphabet,
end with an alphanumeric, and may contrain any alphanumeric characters or hyphen in between.
The hostname must be 63 characters or less.
COMMAND: set network hostename [name] addr
PARAMETER name specifies the network hostname.
set network ip eth0
Caution: This command is not supported for Unified IC.
This command sets the IP address for Ethernet interface 0.
The system asks whether you want to continue to execute this command. If you continue, this
command causes the system to restart.
COMMAND: set network ip eth0 <addr> <mask>
PARAMETERS:
addr is the IP address.
mask is the mask.
set network ipv6
These commands are used for configuring the IPv6 feature on the machine.
COMMANDS:
set network ip dhcp action reboot This command is used for enabling or disabling the DHCPv6
client.
set network ip service action reboot reboot This command is used for enabling or disabling
the IPv6 feature client.
set network ipv6 static_address addr mask This command is used for setting the static IPv6
address on the the server.
PARAMETERS:
Action is mandatory can can have either of these values: {enable | disable
mask is the mask.
Reboot. Reboot after making these changes.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
108
Command Line Interface
Set Commands