Maintenance Manual

[attempts xx] sets the number of times to attempt a DNS request before quitting.
[rotate] causes the system to rotate among the configured DNS servers, distributing the load.
set network dns {primary | secondary}
These commands set the IP address for the primary or secondary DNS server. Entering this
command prompts for verification and, if executed, causes a loss of network connectivity.
COMMANDS:
set network dns primary addr
set network dns secondary addr
PARAMETER addr specifies the address of the server.
set network domain
This command sets the domain name for the system. Entering this command prompts for
verification and, if executed, causes a loss of network connectivity.
COMMAND: set network domain name
PARAMETER name specifies the name of the domain.
set network failover
These commands enable and disable Network Fault Tolerance on the Media Convergence Server
network interface card. Entering the command prompts for verification and, if executed, causes
the system to restart.
COMMANDS:
set network failover ena op
set network failover dis op
PARAMETER op indicates the operation.
set network gateway
This command enables you to configure the IP address of the network gateway. Entering this
command prompts for verification and, if executed, causes the system to restart.
COMMAND: set network gateway addr
PARAMETER addr specifies the address of the gateway.
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
107
Command Line Interface
Set Commands