Maintenance Manual

COMMAND: set ipsec policy_name [policy_group] [policy_name] Use to enable a policy

with a given policy name and group. Example:set ipsec policy_name group1 name1

set logging

These commands allow you to enable or disable logging.

COMMANDS:

set logging enable

set logging disable

set network

set network cluster publisher

Caution: These commands are not supported for Uniﬁed IC.

set network cluster publisher hostname This command conﬁgures the cluster publisher

hostname and cause a temporary loss of network connectivity whil the network is restarted with

the new conﬁguration.

set network cluster publisher ip This command conﬁgures the cluster publisher ip address

and cause a temporary loss of network connectivity whil the network is restarted with the new

conﬁguration.

set network dhcp eth0

These commands set the ethernet interface to disable dhcp (if enabled) or to use dhcp (if not

already enabled). Entering this command prompts for veriﬁcation and, if executed, causes the

system to restart.

COMMANDS:

set network dhcp eth0 enable

set network dhcp eth0 disable

set network dns options

This command allows you to set the dns options.

COMMAND: set network dns options [options]

OPTIONS:

[timeout xx] sets the DNS request timeout in seconds.

Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)

106

Command Line Interface

Set Commands