Maintenance Manual

PARAMETER enable enables account locking.
PARAMETER disable disables account locking.
PARAMETER unlocktime Use this command to configure the unlock time for admin accounts
in seconds. Acceptable values are equal to or greater than 300 seconds but less than 3600 seconds
(60 mins).
set cert
This command regenerates the certificate for the unit name. See also show cert (page 116).
COMMANDS:
set cert bulk unit | all This command consolidates all the certificates available for this unit in
the pre-configured sftp location and exports the consolidated file to the same sftp location.
set cert export unit | allThis command consolidates all the certificates available for this unit
in the pre-configured sftp location and exports the consolidated file to the same sftp location.
set cert import unit | allThis command consolidates all the certificates available for this unit
in the pre-configured sftp location and imports the consolidated file to the same sftp location.
set cert regen unit name This command regenerates the certificate for the unit name and prompt
for a restart to activate the regenerated certificate.
set cert sftp This command prompts for the SFTP IP address, server port, User ID, password,
and remote directory information to be used for Bulk operations.
PARAMETERS:
unit and unit name specifies the name of the unit.
set cli
Run this command to set the paginiation of the current CLI session.
COMMAND: set cli pagination name
PARAMETER on or off
set commandcount
These commands change the CLI command prompt, so it displays or hides the number of CLI
commands executed in the current session.
COMMANDS:
set commandcount enable
Administration Console User Guide for Cisco Unified Intelligence Center Release 8.0(3)
104
Command Line Interface
Set Commands