Installation Guide
.
Installation Guide for Cisco Unified Contact Center Management Portal 8.0(1) 25
• Application link This should be the name of the Data Import server, all in
capital letters, with ‘Client’ appended, such as UCCMPClient.
• Application RMI registry port This is the port on the Provisioning Server
for the Unified ICME/Unified ICMH to connect to. For convenience, this
should be configured the same as for the Administration & Data Server RMI
registry port.
Note Each Unified ICME/Unified ICMH that the Portal will be provisioning
must use a unique port. For example if Unified CCMP is configured to
provision 2 dual-sided Unified ICME's then each Unified ICME must be
assigned a unique port number. This port number must be configured in the
Administration & Data Server RMI registry port and in the Application RMI
registry port. It will also be used later when the ConAPI connection is
configured in the Unified CCMP Configuration Manager.
• Application host name The server name or fixed IP address, such as
UCCMP or 240.24.53.107.
3. Click OK, and OK again to save your changes and close the CMS control
console.
For a dual-sided Unified CCMP system there will need to be 2 entries in the CMS
control utility on each separate Administration & Data Server. These entries will
refer to the side-A Unified CCMP Provisioning Server and the side-B Unified CCMP
Provisioning Server.
Configuration Procedure
To configure Unified CCMP server cluster proceed as follows:
1. Go to Start > All Programs > Management Portal > Configuration Manager.
2. The Connect to SQL Server dialog window is displayed. On this window:
• Server Name This option defaults to the current machine and cannot be
changed.
• Database Select the Unified CCMP database that was installed when setting
up the Database Component. If you accepted the default value, this will be
Portal.
• Use Integrated Security Ensure this option is checked.
3. Click OK to open the Configuration Manager.
4. Enter the settings as described in detail below.
5. Click Save to save your settings, or Revert to cancel your changes.
Note When using integrated security, the user running the Configuration
Manager application must have permission to execute SQL on the database
server on which the application is running.
The window displays the following buttons. Click a button to display the relevant
configuration options.