Manual

Cisco Systems, Inc. Page 60
60
Cisco Unified CallConnector Mobility Service
Technical Overview
Reach service will use this shared mobility-ephone to answer the call and try to locate the user at
the specified numbers.
The configuration for the shared appearance mobility-ephone is similar to the mobility-ephone
except that you configure an additional button with the the user‘s primary ephone-DN. Please
follow the steps below:
Step 1. Click Start -> Run
Step 2. Type telnet xxx.xxx.xxx.xxx (xxx.xxx.xxx.xxx would be your CME router IP
address)
Step 3. Enter the username and password
Step 4. Enter config t
Step 5. Type ephone x (x would be the ephone id)
Step 6. Type mac-address AAAA.BBBB.1000
Step 7. Type type 7960
Step 8. Type keep conference
Step 9. Type username ucceph1 password cisco
Step 10. Type button 1:a 2:b 3:c
a, b and c are single-line ephone DNs created for the mobility service.
Step 11. Type button 4:X where X is the user’s primary DN
Step 12. Type exit when finished