Manual

Cisco Systems, Inc. Page 121
121
Appendix B
Enabling Multi-Party Ad Hoc and Meet-Me Conferencing
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
telephony-service
Example:
Router(config)# telephony-service
Enters telephony-service configuration mode.
Step 4
conference hardware
Example:
Router(config-telephony)#
conference hardware
Configures a Cisco Unified CME system for
multi-party conferencing only.
Step 5
sdspfarm units number
Example:
Router(config-telephony)# sdspfarm
units 3
Specifies the maximum number of DSP farms
that are allowed to be registered to the SCCP
server.
Step 6
sdspfarm tag number device-name
Example:
Router(config-telephony)# sdspfarm
tag 2 confdsp1
Permits a DSP farm to register to
Cisco Unified CME and associates it with a
SCCP client interface's MAC address.
Note The device-name in this step must be the
same as the device-name in the associate
profile command in Step 5 of the "SCCP:
Associating Cisco Unified CME with a DSP Farm
Profile" section.
Step 7
sdspfarm conference mute-on mute-
on-digits mute-off mute-off-digits
Example:
Defines mute-on and mute-off digits for
conferencing.
• Maximum: 3 digits. Valid values are the