Manual

2-2

Cisco TEO Adapter Guide for SAP Solution Manager

OL-25939-01

Chapter 2 Managing SAP Solution Manager Targets

Creating SAP Solution Manager Targets

Before you can create or run processes in your SAP Solution Manager environment, you must create the

targets on which the processes will run. You use the New SAP Solution Manager wizard to create SAP

Solution Manager targets.

Note The SAP Solution Manager Adapter requires the dll files for SAP .NET 3.0 Connector for .NET 4.0 on

x64 version 3.0.6.4 or higher. Before you can configure an SAP Solution Manager target, these files

must be installed on the TEO server.

See Installing SAP .NET Connector Files, page 1-5 for instructions on installing these files.

Note When you create an SAP Solution Manager target, you must map the SAP systems that are monitored in

Solution Manager to the SAP System targets configured in TEO. Therefore, you must create SAP System

targets in TEO for the systems that are monitored in Solution Manager prior to creating an SAP Solution

Manager target.

This section guides you through creating an SAP Solution Manager target.

Step 1 On the Definitions workspace, right-click Targets and choose New > SAP Solution Manager to open

the New SAP Solution Manager wizard.

Figure 2-2 Welcome to the New SAP Solution Manager Wizard

Step 2 Click Next.

Note The Required Value icon displayed on a tab or page indicates that the field is required and

is either missing a value or contains an invalid value.