Manual
Table Of Contents
- Preface
- Introduction
- Process Summary
- Prerequisites
- Run the Service Setup Wizard
- VCS System Configuration
- Routing Configuration
- Pre-search Transforms
- Search Rules
- Task 8: Configuring Transforms
- Task 9: Configuring Local Zone Search Rules
- Task 10: Configuring the Traversal Zone
- Neighboring Between VCS Clusters
- Task 11: Configuring Traversal Zone Search Rules
- Task 12: Configuring the DNS Zone
- Task 13: Configuring DNS Zone Search Rules
- Task 14: Configuring External (Unknown) IP Address Routing
- Endpoint Registration
- System Checks
- Maintenance Routine
- Optional Configuration Tasks
- Appendix 1: Configuration Details
- Appendix 2: DNS Records
- Appendix 3: Firewall and NAT Settings
- Appendix 4: Advanced Network Deployments
- Obtaining Documentation and Submitting a Service Request
- Cisco Legal Information
- Cisco Trademark
To configure the necessary external manager (Cisco TMS) parameters:
1. Go to System > External manager.
2. Configure the fields as follows:
VCS Control VCS
Expressway
Address
Enter 10.0.0.14
Same as
VCS
Control
Path
Enter tms/public/external/management/
SystemManagementService.asmx
Protocol Select HTTP or HTTPS
Certificate
verification
mode
Select On or Off
The certificate is only verified if the value is On and the protocol is set to
HTTPS. If you switch this on then Cisco TMS and VCS must have appropriate
certificates.
3. Click Save.
43
Cisco VCS Expressway and VCS Control - Basic Configuration Deployment Guide
Optional Configuration Tasks