Manual

Enabling MOC clients registered on OCS to call endpoints registered on the video network
4. Click Create Zone.
It is recommended that the connection to the “OCS gateway” Cisco VCS uses SIP over TLS to
communicate so that encrypted calls can be handled. H.323 mode should also be enabled, so that
any interworking that has to be done for calls with OCS is carried out on the “OCS gateway” Cisco
VCS.
5. Configure the following fields:
SIP mode On
SIP port
5061 (or the value that is the same as that configured on the “OCS
gateway” Cisco VCS for TLS mode SIP)
SIP transport TLS
H.323 mode On
In the Location section:
Peer 1 address
IP address or FQDN of the video network Cisco VCS (or the 1
st
Cisco VCS in the Video network cluster)
In the Location section:
Peer 2 address to Peer
6 address
IP address or FQDN of the 2
nd
to 6th video network cluster peers
(if any)
In the Advanced section:
Zone profile
Default
6. Click Save.
Note: Do not worry about the status section indicating Failed. This will change to Active once the
zone’s IP address / FQDN has been saved.
Cisco VCS Deployment Guide: Microsoft OCS 2007 R1 and R2 and Cisco VCS X5.2 Page 52 of 92