Manual
Enabling endpoints registered on the video network to call MOC clients registered on OCS
5. For SIP over TLS configure the following fields:
SIP mode On
SIP port
5061 (or the value that is the same as that configured on OCS for
Cisco VCS access over TLS)
SIP transport TLS
Not recommended, but if SIP over TCP is required, configure the following fields:
SIP mode On
SIP port
5060 (or the value that is the same as that configured on OCS for
Cisco VCS access over TCP)
SIP transport TCP
6. For TLS and TCP configure the following fields:
H.323 mode
Off (H.323 access is not required for communication with OCS)
In the Location section:
Peer 1 address
FQDN of OCS (OCS Director, Hardware Load Balancer or FEP as
appropriate), for example: enterprisepool.test-customer.com
In the Advanced section:
Zone profile
Microsoft Office Communications Server 2007
Note: ‘Appendix 5 – Advanced parameters set by selecting zone profile ‘Microsoft Office
Communications Server 2007’ identifies the advanced configuration values that selecting
Microsoft Office Communications Server 2007 selects.
7. Click Save.
Note: Do not worry about the status section indicating Failed. This will change to Active once the
zone’s IP address / FQDN has been saved.
Note: OCS does not accept INVITEs with no SDP; it requires the calling party to choose the audio
and video codecs. When interworking an H.323 call to Microsoft OCS 2007, Cisco VCS offers a
default set of codecs. By default Cisco VCS chooses a sensible audio and video codec for OCS, but
see Appendix 6 – Setting default codecs for H.323 to SIP calls if it is desired to modify the codecs
offered in the
initial INVITE of an interworked call.
Set up a Search rule to select what gets routed to the OCS zone
Search rules are used to specify the URIs to be forwarded to this neighbor OCS (for example, by
matching the domain of the destination or by matching some element in the URI).
Search rules can also be used to transform URIs before they are sent to a neighbor, for example to
add or modify the domain or add, remove or translate user-id prefixes and even to add extra tags to
SIP URIs, such as user=phone (see “Appendix 8 – TEL URI handling for Cisco VCS to OCS calls” for
further info
rmation about user=phone).
For this scenario, anything with a domain test-customer.com will be matched (and passed to OCS); no
transformation is required.
(“Appendix 7 – Presence with and without transforms“ provides additional details about using
transfo
rms and what needs to be done if presence is to be used when transforms are applied in the
Search rule.)
1. Go to the Search rule page (VCS configuration > Search rules > Rules).
2. Click New.
Cisco VCS Deployment Guide: Microsoft OCS 2007 R1 and R2 and Cisco VCS X5.2 Page 47 of 92