Manual

Enabling endpoints registered on the video network to call MOC clients registered on OCS
Enabling endpoints registered on the video
network to call MOC clients registered on OCS
This is configured in 4 stages:
1. Video Network Cisco VCS Control Configuration
2. “OCS gateway” Cisco VCS Control configuration (1)
3. OCS Configuration
4. “OCS gateway” Cisco VCS Control configuration (2)
Video network Cisco VCS Control configuration
The video network must have a link to the “OCS gateway”; to configure this:
1. Set up a neighbor zone to the “OCS gateway” Cisco VCS (cluster).
2. Set up a Search rule to route calls with the OCS domain to the “OCS gateway” Cisco VCS
(cluster).
Note: In small test and demo networks this configuration is not necessary - the video network Cisco
VCS is the “OCS Gateway” Cisco VCS. Go to ‘“OCS gateway” Cisco VCS Control configuration (1)’
on page 28.
Set up a neighbor zone to the “OCS gateway” Cisco VCS (cluster)
1. Go to the Zones page (VCS Configuration > Zones).
2. Click New.
3. Configure the following fields:
Name
An appropriate name, for example “To OCS gateway”
Type
Neighbor
Cisco VCS Deployment Guide: Microsoft OCS 2007 R1 and R2 and Cisco VCS X5.2 Page 26 of 92