Installation Guide

Initial configuration
Password:
7. Enter the default password of TANDBERG and press Enter.
You will get the install wizard prompt:
Run install wizard [n]:
8. Type y and press Enter.
9. Follow the prompts given by the install wizard to specify the following:
l the password you want to use for your admin account
For security reasons you are advised to change the password from the default of
TANDBERG.
l whether you want to use IPv4, IPv6 or Both
l the LAN 1 IP address of the Cisco VCS
l the LAN 1 IPv4 subnet mask of the Cisco VCS (if you have selected IPv4)
l the IP default gateway of the Cisco VCS
l the Ethernet speed
Use the default value of Auto unless the switch to which you are connecting is unable to
auto-negotiate.
l whether you want to use SSH to administer the Cisco VCS
After the wizard is finished the following message will appear:
Setting other settings...
OK. The system must be restarted for new
settings to take effect..
And you will get a restart prompt:
Restart Now?
10. Type y and press Enter.
11. Disconnect the serial cable and store it in a safe place.
After it has rebooted, the Cisco VCS is ready to use. For security reasons you are advised to change
the password for the default admin account (if you have not already done so) and the root account from
the default of TANDBERG. See the sections "Changing the admin account password" on page 9 and
"Changing the root account password" on page 9 for details.
The IP configuration made using the install wizard applies to the LAN 1 Ethernet port
only. If you have enabled the LAN 2 port (by installing the Dual Network Interfaces option
key) you must use the web interface or CLI to configure the LAN 2 settings.
VCS Getting Started Guide Page 7 of 12