Leaflet
333: I installed a video camera to the video input number 2 on my C90 using component video,
now I am not able to get any video when I activate this source. Why?
363: Is transcoding supported for the H.239/dual stream?
524: Are there any shortcuts on the TRCV remote control?
528: Which resolutions do the video systems support at 60 fps?
545: Can I deploy endpoints from outside the enterprise network, for example, from a home
oce or remote oce without VPN connection
558: How do I record my video calls?
609: My computer is connected to the DVI-I input of the EX90, but the desktop is not displayed
on the screen. Why?
610: What resolutions does the EX90 support on the DVI-I PC-screen input?
611: Can I run MultiSite on EX and MX video systems?
617: Which provisioning mode do the codes support?
620: Can I send content on the EX90 using HDMI 1 as input source?
622: Can I use the MX and EX systems as a USB hub?
630: I have the C40 DVI output congured as a second monitor, but when connecting to the DVI-I
output on the C40 codec, nothing is displayed on the screen, why?
631: When connecting to the second HDMI output on the Cisco TelePresence Codec C20, C40,
SX20 or EX90, nothing is displayed on the screen, why?
667: My computer is connected to the DVI-I input, but the desktop is not displayed on the screen.
Why?
694: How do I setup a Cisco TelePresence video system so that I am not disturbed by incoming
calls when I am already in a call?
695: Which congurations on my video system require a reboot to take eect?
697: How can I set up self view in full screen mode on my secondary monitor?
701: Which systems do not support H.323?
300: The monitor does not go to standby mode when it is connected to a codec.
302: How do I change the output for my On Screen Display (OSD) from HDMI1 to another output
when the system is used with the TRCV remote control?
303: My C Series Codec does not seem to boot up (no video is displayed on the monitor), why?
313: I changed the video output on my codec to a new resolution not supported by the monitor,
how do I revert this?
318: My Pioneer plasma monitor does not display the image correctly from my codec. Why?
319: My monitor displays the image from my codec outside of the monitor frame, why?
325: There is no audio coming out from my codec when it is connected to my monitor with a
HDMI cable, why?
609: My computer is connected to the DVI-I input of the EX90, but the desktop is not displayed
on the screen. Why?
610: What resolutions does the EX90 support on the DVI-I PC-screen input?
630: I have the C40 DVI output congured as a second monitor, but when connecting to the DVI-I
output on the C40 codec, nothing is displayed on the screen, why?
662: What should I do before contacting TAC?
667: My computer is connected to the DVI-I input, but the desktop is not displayed on the screen.
Why?
688: How can I use a dedicated monitor for showing presentations only?
689: How do I select which monitor output is primary and which is secondary?
699: Can the SX80 DVI-I output support Composite or S-Video?
Monitor
Cisco TelePresence TC Endpoints
D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015 Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
7
Knowledge Base Articles
Contents
Introduction
Questions
Contact
Questions and answers
Appendices
Questions and answers