Leaflet

695: Which congurations on my video system require a reboot to take eect?
The following congurations require a reboot to take eect:
TC5:
y xConguration NetworkServices HHTP Mode
y xConguration NetworkServices HHTPS Mode
y xConguration RTP Ports Range Start
y xConguration RTP Ports Range Stop
y xConguration Network 1 Speed
y
xConguration Network 1 IPStack (when switching from IPv4 to IPv6; not from IPv6
to IPv4)
y xConguration Security Audit Server Address
y xConguration Security Audit Server Port
y xConguration Security Audit OnErrorAction
y xConguration Security Audit Logging Mode
y xConguration Network Port 2 Mode: Requires reboot
TC6:
y xConguration NetworkServices HHTP Mode
y xConguration NetworkServices HHTPS Mode
y xConguration RTP Ports Range Start
y xConguration RTP Ports Range Stop
y xConguration Security Audit Server Address
y xConguration Security Audit Server Port
y xConguration Security Audit OnErrorAction
y xConguration Security Audit Logging Mode
y xConguration Network Port 2 Mode: Requires reboot
TC7:
y xConguration RTP Ports Range Start
y xConguration RTP Ports Range Stop
y xCommand SystemUnit CongurationProle Change
Applies to the following products:
y SX20 Quick Set
y Codec C20
y Codec C40
y Codec C60
y Codec C90
y MX200
y MX300
y MX200 G2
y MX300 G2
y MX700
y MX800
y EX60
y EX90
696: What kind of external speakers can I use with the C20 and SX20 codecs?
You should use active speakers that are non-grounded. Attaching a grounded active speaker
to the system creates a ground loop, which causes an annoying humming sound.
Another option is to use a ground isolator between grounded speakers and the codec.
Applies to the following products:
y SX20 Quick Set
y Codec C20
697: How can I set up self view in full screen mode on my secondary monitor?
This is possible with TC6.0, and later software versions. To achieve this, use the following
congurations:
1. xConguration Video SelfviewDefault OnMonitorRole: second
2. xConguration Video SelfviewDefault FullscreenMode:on
To change the congurations on the web interface, go to Conguration > System Conguration
> Video > SelfviewDefault. From OnMonitorRole select Second and from FullscreenMode
select On. Click Save to conrm the changes.
Applies to the following products:
y SX20 Quick Set
y SX80
y Codec C20
y Codec C40
y Codec C60
y Codec C90
y MX200
y MX300
y MX200 G2
y MX300 G2
y MX700
y MX800
y EX60
y EX90
Cisco TelePresence TC Endpoints
D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015 Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
25
Knowledge Base Articles
Contents
Introduction
Questions
Contact
Questions and answers
Appendices
Questions and answers