Leaflet
524: Are there any shortcuts on the TRCV remote control?
The following remote control shortcuts are available:
Quick access
y Home menu: Press the OK / V key when no menus are shown (same as pressing the
home key in any menu).
y
System Information and Call status : Press the right-most function key on the home
menu.
y
Advanced Conguration: Press the fourth function key (from left) on the System
Information and Call status page. The quick key sequence is "home- right-most
function key - fourth function key" (or "V- right-most function key - fourth function
key" when no menus are shown).
Quick Call
y Call menu: Press any number key in idle mode (when not in a call).
y Recent calls: Press the call key when the Call menu is not visible.
y Dial last number: Press the call key twice.
Camera Control
y Camera control soft menu : Press any arrow or zoom key in idle mode.
y Camera presets: Press the number key corresponding to the desired camera preset
on the Camera control soft menu to change preset.
Other
y Standby mode: Press and hold the Disconnect-key for 5 seconds.
y
Restore resolution and OSD: When not in a call, enter the sequence following sequence
with the remote control "Disconnect-key - * - # - * - # - 0 - x - #" where x is output
1 to 4 to change the OSD and restore the resolution (1280×720@60Hz for HDMI and
1024×768@60Hz for DVI) to the selected output.
y
DTMF: Pressing a number key in a call gives the DTMF (Dual Tone Multiple Frequencies)
sound for the pressed number.
Applies to the following products:
y SX20 Quick Set
y Codec C20
y Codec C40
y Codec C60
y Codec C90
Related questions:
302: How do I change the output for my On Screen Display (OSD) from HDMI1 to another
output when the system is used with the TRCV remote control?
528: Which resolutions do the video systems support at 60 fps?
The supported resolutions at 60 fps are w288, w448, w576 and w720.
Please note the following:
y The Cisco TelePresence Codec C20, SX20, MX200, MX300 and EX60 can encode
60 fps in point-to-point calls, but not if a presentation is running at the same time.
y The Cisco TelePresence Codec C40, C60 and EX90 can encode 60 fps in point-to-
point calls, also when presentations are running at the same time, but not in MultiSite.
y The Cisco TelePresence Codec C90 can encode 60 fps in point-to-point calls, when
running presentations, and in MultiSite.
Applies to the following products:
y SX20 Quick Set
y Codec C20
y Codec C40
y Codec C60
y Codec C90
y MX200
y MX300
y EX60
y EX90
Related questions:
530: What is the relationship between transmitted frame rate and bandwidth on the video
systems?
Cisco TelePresence TC Endpoints
D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015 Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
16
Knowledge Base Articles
Contents
Introduction
Questions
Contact
Questions and answers
Appendices
Questions and answers