Leaflet

300: The monitor does not go to standby mode when it is connected to a codec.

When a codec goes to standby, all monitor outputs are disabled. Some consumer monitors

do however not go into standby when they receive no video on the HDMI input. In the newer

releases TC4.2 and higher, we have implemented CEC (Consumer Electronics Control). This

allows the codec to signal standby to a monitor.

Applies to the following products:

y SX10 Quick Set

y SX20 Quick Set

y SX80

y Codec C20

y Codec C40

y Codec C60

y Codec C90

302: How do I change the output for my On Screen Display (OSD) from HDMI1 to another output

when the system is used with the TRCV remote control?

Conguring the OSD output from the menu on screen

You can change this in the GUI through the administrator settings. From the Home menu

select Settings > Administrator settings > Advanced conguration > Video > OSD and set

Output to the relevant video output.

Conguring the OSD output using an API command

You can use an API command to set the OSD output to the relevant video output. Log in as

admin using SSH (secure shell) and execute the command:

xConguration Video OSD Output: <1-4>

Conguring the OSD output using the remote control

You can use a special sequence on the remote control.

Use the remote control to enter the following sequence: 'Disconnect-key * # * # 0 X #'

where X = the video output where you want to display the OSD.

y X = 1 for HDMI 1

y X = 2 for DVI 2 (HDMI 2 for C20)

y X = 3 for HDMI 3

y X = 4 for DVI 4